Ungawafaka Kanjani Amadivayisi Eshalofini elingu-19 Intshi

首图.png

  

I was required to install a transmitter into a 19 ″ tools shelf. Because it was hefty, as well as having installed hefty devices into a shelf I needed an easy means to do that. If you have ever before installed something heavy on a 19-inch device's shelf, it is rather difficult. Despite having 2 people. Often 3 people are required. This is what I created to make mounting equipment into a rack a whole lot easier.

  

Considering that mostly all 19" devices racks use 10-32 screws in their side rails, get 2 of them and also place 2 10-32 nuts on the screw, and jam them with each other. Then clamp the whole point in a vise.

  

Below is a picture of what I am speaking about:

  

1.jpg

  

As soon as the screw is in the vise, take a hacksaw and also cut off the head of the screw. Then cut a vertical slot with the hacksaw right where you removed the head. The objective of the vertical port is so you can use a screwdriver on it. so ensure you reduced the port deep sufficient. You will require 2 of these for installing tools into a 19-inch equipment rack.

  

To utilize them, you need to figure out which holes in the side rails you will certainly be utilized for placing your equipment in the rack. In the leading a lot of holes that you are most likely to make use of on each rail, merely screw in one of these unique screws.

  

Now it's time to mount your devices. All you do is slide your devices' top mounting holes onto the screws. This will correctly straighten your openings, and all you have to do is press the bottom of your devices up against the rack, and also these two screws will hold the weight of your equipment for you. Just put in both bottom screws initially, after that the rest of them right into the rails of your device's shelf.

  

Below is an image of one of the tailored screws after the tools is mounted:

  

2.jpg

  

To end up the task, simply take a screwdriver and also unscrew these two screws and also change them with the proper screws and you are done installing your devices into the shelf.

  

This write-up was originally uploaded on www.mikestechblog.com Any recreation on any other site is restricted and also an infraction of copyright regulations.

Yabelana ngalesi sihloko

Thola okuqukethwe kweviki okuhamba phambili kokumaketha

Okuqukethwe

    Izihloko ezihlobene Nalesi

    INQUIRY

    XHUMANA NATHI

    contact-email
    contact-logo

    I-FMUSER INTERNATIONAL GROUP LIMITED.

    Sihlala sinikeza amakhasimende ethu imikhiqizo ethembekile nezinsizakalo ezicabangelayo.

    Uma ungathanda ukuxhumana nathi ngqo, sicela uye ku Xhumana nathi

    • Home

      Ikhaya

    • Tel

      Tel

    • Email

      imeyili

    • Contact

      Oxhumana naye